Range and cooktop problems come in a few familiar forms: a gas burner that clicks but won’t light, an electric burner that stays cold or runs too hot, and an oven that won’t heat or holds the wrong temperature. Across 645 oven and range calls in our records since 2024, control boards (54) and igniters (45) were the most common repairs, followed by bake or broil elements (26) and surface elements or burner switches (20).
At a glance
- A gas burner that clicks but won’t light usually needs its cap reseated or its ports cleaned. If it doesn’t click at all, the igniter switch or spark module is next.
- A dead or runaway electric burner is often the burner switch or wiring, not only the element.
- Gas ovens that won’t heat most often need an igniter. Electric ovens most often need a bake element.
- If you smell gas, don’t try to light anything. Leave and call your gas company from outside.
Gas burner clicks but won’t light
Since 2024 we have been called out for a gas burner that won’t light 26 times. Start with the simple causes: a burner cap that is off-center or wet after a spill, and burner ports clogged with food. Let the burner cool, lift the cap, clean the ports with a dry brush or a straightened paper clip (not a toothpick that can break off), dry everything and reseat the cap so it sits flat.
If none of the burners click, or one clicks constantly, the problem is electrical: an igniter switch, the spark module or the harness. On a gas range in Denver with a dead burner, we replaced the igniter switch and harness and cleaned the burners.
Full guide: gas burner won’t light.

Electric burner not working or too hot
We have been called out for an electric burner that won’t work 30 times since 2024. On coil cooktops, swap the dead coil with a working one of the same size: if the problem moves, the coil is bad; if it stays, the receptacle, switch or wiring is. On smooth glass-top cooktops the element sits under the glass, and a burner that won’t turn on or won’t turn down usually needs its control switch. On a Samsung glass cooktop in Denver with burners running too hot and one not working at all, three control switches were replaced.
Full guide: electric burner not working.

Oven won’t heat
On gas ovens, the igniter is the classic failure: it glows but too weakly to open the gas valve, so the oven never lights. Igniters were the second most common oven and range repair in our records. On a Viking oven in Denver whose igniters stopped working, we replaced two burners and two igniters. On electric ovens, look for a broken or blistered bake element; check the breaker first, because a tripped half of the 240-volt circuit can leave the cooktop working and the oven cold.
Full guide: oven not heating.

Oven temperature is off
If food burns or comes out underdone, check the oven with an oven thermometer before replacing parts. Many ovens let you adjust the calibration offset from the control panel. A failing temperature sensor, a worn door gasket or a weak igniter can also make an oven run cold. At Denver’s altitude, recipes need adjusting too; see altitude and your appliances.
Full guide: oven temperature wrong.
Control boards and error codes
Control boards were the most common oven and range repair in our records. A board fault often shows as an error code, an unresponsive keypad or an oven that heats without stopping. Not every code means a new board, though: a JennAir oven in Boulder showing a stuck-key code was fixed by reconnecting the control panel connector. Look up your code on our error code pages.
What you can safely check yourself
- Clean and reseat gas burner caps, and let wet burners dry fully.
- Swap coil elements between burners to test them.
- Check the breaker for electric ranges and the gas valve behind gas ranges.
- Test oven temperature with an oven thermometer before changing settings.
- Leave igniters, gas valves, wiring and anything under the glass top to a technician.
Frequently asked questions
Why does my gas burner click but not light?
Usually a misaligned or wet burner cap or clogged burner ports. If cleaning and reseating the cap doesn’t fix it, the igniter or its switch may need testing.
Why won’t my gas oven heat when the burners work?
The oven igniter is the most common cause. A weak igniter glows but can’t open the oven’s gas valve.
Can I replace a glass cooktop element myself?
It requires removing the glass top and working with high-voltage wiring. We recommend a technician.
Burner, cooktop or oven acting up? Call 720-230-1229. For holiday baking, see our oven checklist for Thanksgiving.
Keep Exploring
Get it fixed
Range & Cooktop repair by city
Troubleshooting guides
Maintenance guides
Error codes by brand
More from our blog
How to prevent this
Many of these breakdowns start with maintenance that was skipped. These guides show what to check, how often, and what happens if you don't: