Refrigerator Maintenance: What to Clean, Check and Replace

Updated November 2026 · By Zach, EPA 608-certified appliance technician, The Appliance Team, Denver CO

Quick answer

Keep the fresh-food section at 37–40°F and the freezer at 0°F, clean the condenser coils every few months (more often with pets), check the door gaskets, and change the water filter about every six months. Most expensive refrigerator repairs we do start with a cooling system that has been working too hard for too long.

Refrigerator maintenance tasks

Pick a task to see the full guide: what the part does, what happens when it’s neglected, step-by-step instructions, brand notes and photos from our service calls.

!

What skipping refrigerator maintenance leads to

Most expensive refrigerator repairs we see didn’t start as big problems. They started as a dusty coil, a folded gasket or a slow drain that was left alone for months.

Bottom lineAbout an hour of maintenance a few times a year protects the parts that are most expensive to replace: the compressor, the sealed system, the fans and your floor.

Maintenance schedule

Task How often
Check temperatures with a thermometer Monthly
Wipe and inspect door gaskets Monthly
Clean the condenser coils Every 3 to 6 months, sooner with pets or dust
Replace the water filter About every 6 months, or when the light comes on
Clean the drain pan and defrost drain Once or twice a year
Check the water line behind the fridge Once a year

1. Clean the condenser coils

The condenser releases the heat the refrigerator pulls out of your food. When it is packed with dust and pet hair, the compressor runs longer and hotter. Whirlpool’s guidance is to inspect and clean the coils every 3 to 6 months in homes with pets, heavy kitchen traffic or construction dust. Some newer models have sealed or rear coils that don’t need routine cleaning; your Use and Care Guide says which you have.

  1. Unplug the refrigerator or switch off its breaker.
  2. Remove the base grille at the bottom front, or pull the unit out if the coils are on the back.
  3. Vacuum the coils and the area around them with a brush attachment or a coil brush. Don’t bend the fins or tubing, and don’t disturb the water line.
  4. Put the grille back and restore power.

2. Check the door gaskets

A torn or dirty gasket lets warm, humid air in, which builds frost and makes the refrigerator run constantly. Wipe the gaskets with warm soapy water and check the seal by closing the door on a sheet of paper at several points: it should hold the paper firmly.

3. Keep the right temperatures

The FDA recommends keeping the refrigerator at or below 40°F and the freezer at 0°F. Use an appliance thermometer rather than trusting the dial. If the fresh-food section is warm while the freezer is cold, an air or defrost problem is usually starting.

4. Replace the water filter

Most manufacturers recommend changing the filter about every six months. A clogged filter slows the water dispenser and starves the ice maker. In hard-water cities it matters even more; see hard water in the Denver metro.

5. Clear the defrost drain and check the water line

A clogged defrost drain is a common cause of water on the floor or ice under the crisper drawers. Once or twice a year, check that water drains freely. Behind the refrigerator, look at the water line and its connections for drips or kinks.

What we find when maintenance is skipped

Across 1,685 refrigerator calls in our records since 2023, the most common repairs were the compressor or sealed system (167 calls), evaporator or condenser fans (121) and control or inverter boards (120). Dirty condensers and blocked airflow don’t cause every one of these, but they make all of them more likely. Ice makers (109) and defrost systems (66) round out the list.

When to call a technician

  • The refrigerator runs constantly or the back and sides feel hot.
  • The fresh-food section is warm while the freezer is cold.
  • Frost keeps building on the back wall of the freezer.
  • Water collects under the crisper drawers or on the floor.

Already having trouble? See refrigerator not cooling and refrigerator leaking water.

Brand-by-brand notes

Brand Maintenance that matters most
LG Clean the condenser once or twice a year. Compressor and sealed-system problems were the largest share of our LG refrigerator calls.
Samsung Watch for ice on the freezer floor and frost behind the fresh-food panel. Keep the defrost drain and door seals in good shape.
GE / Café / Profile Most models since 2001 have a NeverClean condenser, but fans and the defrost drain still need attention. Clogged drains led our GE leak calls.
Whirlpool / KitchenAid / Maytag Coils every 3 to 6 months with pets. Check the French-door center flap and the water inlet valve.
Sub-Zero Condenser every 6 to 12 months; respond to the “Vacuum Condenser” reminder.

Frequently asked questions

How often should I clean refrigerator coils?

Every 3 to 6 months in homes with pets or a lot of dust, less often otherwise. Some models don’t need routine coil cleaning; check your manual.

What temperature should my refrigerator be?

At or below 40°F for the fresh-food section and 0°F for the freezer, according to the FDA.

How often should I change the refrigerator water filter?

About every six months, or when the filter indicator comes on.

Want a technician to do it? Call 720-230-1229. We serve Denver, Boulder County and 52 surrounding cities.

720-230-1229
720-230-1229

Photos from our job records

Real photos our technicians took on repair calls around Denver and the Front Range. Each caption says where the job was.

Refrigerator repair in Niwot, photo from our job records
Refrigerator repair in Niwot
Refrigerator repair in Edgewater, photo from our job records
Refrigerator repair in Edgewater
Refrigerator repair in Firestone, photo from our job records
Refrigerator repair in Firestone
Refrigerator repair in Firestone, photo from our job records
Refrigerator repair in Firestone
Call Now Book Online