When an LG washer leaks, most people blame the door boot. In our records the most common source is the water inlet valve at the back of the washer, where the hoses connect. We have repaired more than 400 LG washers that were leaking. In the 46 calls with detailed notes in our current job system, the inlet valve was replaced or needed in 15, the door boot or gasket was the problem in 8, and the drain pump, drain hose or filter in 6.
This guide is written from our own job records. 46 of our LG washer leak calls, from 2024 to October 2026, are in our current job system with detailed notes, across Boulder, Longmont, Denver, Littleton, Erie, Golden, Arvada, Thornton and the rest of the metro. The photos are from those calls.
What 46 detailed LG calls show
| Where the leak came from | Calls | Typical part or fix |
|---|---|---|
| Water inlet valve | 15 | 5221ER1003A, 5220FR2006H (hot), 5220FR2075L, AJU75152601 |
| Door boot or gasket | 8 | MDS47123608, MDS47123605, 4986ER0006B |
| Drain pump, drain hose or filter | 6 | 4681EA2001T drain pump, drain hose reconnected |
| Detergent dispenser | 2 | 4925ER1015B |
| Supply hoses or an internal hose | 2 | New fill hoses, pressure hose reattached |
Notes are short and on some calls no single source was recorded, so these are minimums. The pattern is clear, though: on LG washers, a leak at the back or underneath usually starts at the inlet valve, and a leak at the front usually starts at the door boot.
The most common source: the water inlet valve

The inlet valve is where the hot and cold hoses connect. Inside, solenoids open to let water in. Over time the plastic body cracks or the seals wear, and the valve drips at the connection or leaks inside the cabinet. The water runs down and shows up under the washer, so it is easy to mistake for a tub or drain leak.

The valve we replace most often on LG front-loaders is 5221ER1003A: it shows up on five of our tickets, in Lyons, Erie, Frederick, Superior and Longmont. On older models the hot and cold valves are separate parts, and in Centennial and Boulder only the hot water valve was leaking (5220FR2006H). LG top-loaders use a different valve assembly (AJU75152601 or AJU75152602).
Signs that point to the valve:
- Water under the back of the washer, often when it is filling.
- Drips or mineral crust at the hose connections.
- Water on the floor even when the washer is not running, if the valve does not fully close.
Door boot and gasket leaks

The rubber door boot seals the door to the tub. Tears, holes, buildup in the folds and items caught in the seal all let water out at the front. On a Boulder call the gasket had tangled with clothes and the washer started leaking from the front. In Louisville the fix included cleaning the drain holes in the gasket along with a new cold water valve.

A leak does not always show while the technician is watching. In Boulder we ran a full 30 minutes of a cycle without a drop, but the water marks under the door showed where it had been coming from, and we recommended a new gasket (MDS38265303).

Drain pump, drain hose and filter

On front-loaders the drain pump sits behind the small door at the bottom front, with a filter and a short drain hose. In Denver one leak was simply a filter cap that the owner could not screw back in after cleaning it. In Littleton and Henderson the drain pipe had come loose or needed replacing, and in Parker the drain pump itself (4681EA2001T) needed to be replaced.
Video: LG front-load washer leaks
Video by LG USA
What we see on Denver calls
- On our 46 detailed LG washer leak calls, the water inlet valve was the most common source: 15 calls (5221ER1003A, 5220FR2006H for hot water, 5220FR2075L, AJU75152601).
- Door boot or gasket: 8 calls. Drain pump, drain hose or filter: 6 calls.
- Most people blame the door boot first, so check the back of the washer where the hoses meet the valve too.
Don’t want to do it yourself? Call 720-230-1229.
Safe checks before you call
- Turn off the water and unplug the washer before you look around it.
- Dry the floor, then run a short cycle and watch where the water appears first: back, front or under the bottom-front door.
- Check the supply hoses and their connections at the wall and at the washer. Replace rubber hoses that bulge or crack.
- Look at the door boot: pull the folds open and check for tears, holes, buildup and small items.
- Check that the drain filter cap at the bottom front is screwed in fully and the little drain hose is capped.
- Use only HE detergent and the right amount. Too much soap can foam out of the dispenser or the door.
- Write down the model number from the label inside the door, such as WM3570HWA or WM2016CW.
What it costs
Washer repairs on our price list start from $179 for labor, with parts quoted separately. The home diagnostic visit is from $59 and is credited toward the repair. See our prices.
When to call a technician
- Water appears at the back or underneath while the washer fills.
- The floor gets wet even when the washer is off.
- The door boot is torn or the leak at the front keeps coming back.
- The washer leaks and also shows a drain error or stops mid-cycle.
We repair LG washers across 52 Denver-area cities. See LG washer repair, LG washer error codes and our general guide to washers leaking.
How to prevent this
Many of these breakdowns start with maintenance that was skipped. These guides show what to check, how often, and what happens if you don't:
Frequently asked questions
Why is my LG washer leaking from the bottom?
In our records the most common cause is the water inlet valve at the back. Water from the valve runs down inside the cabinet and shows up under the washer. The drain pump, the drain hose or a loose filter cap are the next suspects.
Why is my LG front-load washer leaking from the front?
Usually the door boot: a tear, buildup in the folds, or clothes caught in the seal. Too much detergent can also push foam out through the door or the dispenser.
Can I keep using an LG washer that leaks?
It is better not to. Turn off the water when the washer is not in use and call for service. A leaking inlet valve can let water in even when the washer is off.
Is it worth fixing a leaking LG washer?
Usually yes. Inlet valves, door boots and drain pumps are common, contained repairs. If the tub or the bearings are damaged, compare the repair with a new washer.
Why did the leak not show up during the service visit?
Some leaks only happen in one part of the cycle or with a full load. Water marks, mineral trails and stains help the technician find where the water has been coming from.