Dryer Moisture Sensor Cleaning

Updated November 2026 · By Zach, EPA 608-certified appliance technician, The Appliance Team, Denver CO

Quick answer

Wipe the two metal sensor bars inside the drum every month or two with rubbing alcohol on a soft cloth. Fabric softener and dryer sheets coat them, and the dryer can no longer tell when clothes are dry.

How auto-dry works

Most modern dryers have two metal strips near the lint screen or on the drum baffle. Wet clothes touching them close a tiny electrical circuit. As the clothes dry, the signal changes and the control board decides when to stop.

A thin film of softener or dryer-sheet residue insulates the bars, so the readings go wrong.

A dryer in Northglenn opened up for an airflow check
A dryer in Northglenn opened up for an airflow check. We checked the outlet voltage and cleaned the vent.

This guide is part of our dryer maintenance checklist. On the same appliance, also check dryer lint screen cleaning and dryer vent cleaning. Related guides for other appliances: washer tub cleaning and odor prevention.

!

What happens if the sensor bars are coated

This one doesn’t break the dryer, but it costs energy and clothes every load.

1

Residue builds Early

Inside: Softener and dryer sheets leave a waxy coat on the bars.

You notice: Nothing obvious.

2

Wrong readings Growing

Inside: The board gets false dry or false wet readings.

You notice: Cycles end with damp clothes, or run much longer than needed.

3

People switch to timed dry Serious

Inside: Timed cycles often run longer than needed.

You notice: Higher bills, hot, wrinkled clothes.

4

Fabric damage Severe

Inside: Overdrying shrinks and weakens fibers and stresses elastic.

You notice: Shrunk clothes, more lint, stiff towels.

What it can cost you

Damp or overdried laundryHigher energy useShrunken clothesExtra wear on heat parts

Worst caseMonths of overdried loads: higher bills, worn clothes and a heater that runs far more than it needs to.
Inside the drum of a Samsung dryer in Erie that shut off a minute after starting
Inside the drum of a Samsung dryer in Erie that shut off a minute after starting. The moisture sensor was replaced.
✓

What clean sensor bars get you

  • Auto-dry that stops at the right time.
  • Lower energy use.
  • Clothes that last longer.

Warning signs

  • Auto-dry ends with damp clothes.
  • Auto-dry runs very long.
  • You see a dull film on the metal bars.

How to clean the sensor bars

  1. Unplug the dryer.
  2. Find the two metal strips near the lint screen or on a drum baffle.
  3. Wipe them with a soft cloth and rubbing alcohol, or a little white vinegar. Don’t use abrasive pads.
  4. Let them dry and plug the dryer back in.
  5. If you use dryer sheets, clean the bars every month or two.

Brand notes

Brand What to know
Samsung / LG Sensor bars are usually near the lint filter on the front of the drum.
Whirlpool / Maytag Bars are on the lint screen housing on many models.
GE Bars are typically inside the drum near the door.

When to call a technician

  • Auto-dry is still wrong after cleaning.
  • The dryer stops early with a sensor error.

FAQ

Why are my clothes damp when the cycle ends?

Often coated sensor bars. Also a clogged vent or an overloaded drum.

Is it safe to use alcohol?

Yes, on a cloth with the dryer unplugged. Let it evaporate before running the dryer.

Want a technician to do it? Call 720-230-1229. We serve Denver, Boulder County and 52 surrounding cities.

720-230-1229
720-230-1229
Call Now Book Online