Frigidaire Refrigerator Error Codes

Updated November 2026 · By Zach, EPA 608-certified appliance technician, The Appliance Team, Denver CO

Quick answer

When a Frigidaire refrigerator shows H or HI, a compartment has run warm for more than an hour, most often because a door did not close. DISP means cubes are jammed in the chute, and PF means the power dropped. SY EF (evaporator fan), SY CE (control communication), dF (defrost) and OP or SH (temperature sensor) are part failures and need a technician.

Frigidaire’s electronic-control refrigerators put alarms and codes on the temperature display and usually beep with them. A couple of readouts, Sb and 77, are operating modes rather than faults. Before you unplug anything, write the code down: a power cycle often erases it, and the technician will want to know exactly what it said. The meanings below combine Frigidaire’s owner documentation with parts references; codes from the latter are marked “commonly reported”. Settings of 37 °F for fresh food and 0 °F for the freezer are a good baseline while you troubleshoot.

Frigidaire refrigerator codes

Alarms that usually clear on their own

Display What happened Do this
H, HI Fresh food or freezer has been too warm for over an hour; the temperature blinks and a tone sounds. Press Clear Alerts to see the peak temperature reached. Check door gaskets and settings. If it keeps warming, the cause needs diagnosing.
PF Power failure or surge, which may also trigger the warm alarm. Clear Alerts, then judge food by how long the outage lasted.
Door Ajar A door has been open for more than 5 minutes. Close it; if it sounds with the doors shut, something is propping a door.
DI SP, DISP Ice jammed in the dispenser chute. Clear the chute. For a fused bin, thaw it, empty, wash and dry, then reinstall.
Beeping, nothing displayed Brief power interruption or another error. Unplug 2 to 3 minutes and plug back in.

Failed parts

Display What happened Do this
SY EF, 5Y EF, EF Evaporator fan circuit; cold air may not be circulating.
Technician
Press the door switch and listen for the freezer fan. Unplug a minute; a repeat means the fan motor or board.
SY CE, 5Y CE Main board and display failed to talk at power-up.
Technician
Unplug a few minutes. If it returns: wiring, board or display.
SY CF, 5Y CF Sources differ: a power-up communication failure, or a wrong condenser fan feedback signal.
Technician
Five minutes without power, then service if it repeats.
Er CE Commonly reported: a temporary break in board communication.
Technician
Unplug 2 to 3 minutes. Back again, or not cooling? Book a visit.
dF No defrost circuit detected.
Technician
Frost on the freezer back wall confirms it; the heater circuit and board get tested.
OP Fresh-food temperature sensor open.
Technician
One restart; a repeat means the sensor or its wiring.
SH Shorted sensor: freezer sensor if on the freezer readout, fresh-food sensor if on the fridge readout.
Technician
Note which side shows it, restart once.
4 Commonly reported: damper between freezer and fresh food not connected.
Technician
Five-minute power reset, then service.

Modes, not faults

Display What happened Do this
Sb, SB SB Sabbath mode, running minimum functions. Hold the key combination from your manual for five seconds.
77 77 Store demo mode; may not cool. Unplug five minutes and plug back in.

What we actually find on Frigidaire refrigerators in the Denver area

The codes above come from Frigidaire’s own documentation. This section shows what our technicians found once they opened the machine. Since 2023 we have handled 47 Frigidaire refrigerator service calls across the Denver metro and Boulder County. Every number here comes from our own job records.

The Frigidaire refrigerator repairs we do most often

Across all 47 Frigidaire refrigerator calls, with or without a code on the display:

  1. Ice maker: 5 calls
  2. Damper: 3 calls
  3. Control or inverter board: 3 calls
  4. Water inlet valve: 3 calls
  5. Compressor or sealed system: 2 calls

Recent Frigidaire refrigerator calls

  • Longmont (80504), September 2026: Frigidaire refrigerator freezer not freezing. Repair: damper replaced.
  • Wheat Ridge (80033), June 2026: Frigidaire refrigerator freezer not freezing. Repair: defrost system replaced.
  • Longmont (80503), June 2026: Frigidaire refrigerator freezer not freezing. Repair: control or inverter board replaced.
  • Northglenn (80233), June 2026: Frigidaire refrigerator freezer not freezing. Repair: ice maker replaced.

Frigidaire refrigerator repairs from $290. Home diagnostic visit from $59, credited toward your repair. Call 720-230-1229.

Source: The Appliance Team service records, 2023–2026. Customer details removed.

Video: Frigidaire refrigerator error codes

Video by Fix it!

What we see on Denver calls

  • An error code points to the system that reported the fault, not always to the part that failed.
  • The Frigidaire refrigerator repairs we do most often across the Denver metro and Boulder County: ice maker (5 calls), damper (3) and control or inverter board (3).
  • Recent call: Longmont (80504), September 2026: Frigidaire refrigerator freezer not freezing. Repair: damper replaced.

Don’t want to do it yourself? Call 720-230-1229.

Owner checklist

  1. Write the code down before resetting.
  2. Unplug or switch off the breaker for any hands-on check.
  3. Run a hand around both gaskets; they should seal all the way.
  4. Confirm settings and give the unit a few hours after a door was left open.
  5. Clear Alerts, or unplug for 30 seconds to reset alarms.

Book a Frigidaire refrigerator repair if

  • H or HI keeps coming back with doors shut and settings right.
  • SY EF, SY CE, dF, OP or SH appears or returns.
  • Frost builds up on the freezer back wall.
  • The fans are silent and the fridge is warming.

Is the food still safe after an H, HI or PF alarm?

Frigidaire’s Clear Alerts button shows the warmest temperature the compartment reached, which is the most useful number you have. Food-safety guidance from the USDA is simple: perishable food (meat, dairy, leftovers, cut fruit) that sat above 40 °F for more than two hours should be thrown out. Freezer food that still has ice crystals or reads 40 °F or below can be refrozen.

  • Peak reading under 40 °F: keep everything and let the unit recover.
  • Above 40 °F for a short spell after a door was left open: check items with a probe thermometer.
  • Above 40 °F for hours, or repeated alarms with the doors shut: discard perishables and book a repair, because the fridge is not holding temperature on its own.

How to prevent this

Many of these breakdowns start with maintenance that was skipped. These guides show what to check, how often, and what happens if you don't:

All appliance maintenance guides →

Frigidaire refrigerator code FAQ

How do I reset a Frigidaire refrigerator code?

Press Clear Alerts for alarms. For part codes, unplug it for a few minutes; if the code returns, it needs service.

What does SY EF mean?

The evaporator fan circuit failed. Without that fan, cold air does not reach the fresh-food side.

Why is my Frigidaire showing H?

A compartment has been warm for over an hour, usually after a door was left open. Close it and give it time to recover.

What does DISP mean?

Ice is jammed in the dispenser chute. Clear the jam or thaw the bin.

Sources: owner.frigidaire.com, owner.frigidaire.com, appliancepartspros.com, removeandreplace.com, removeandreplace.com, appliancepartspros.com. Codes and meanings can vary by model; check your owner’s manual.

720-230-1229
720-230-1229

Photos from our job records

Real photos our technicians took on repair calls around Denver and the Front Range. Each caption says where the job was.

Refrigerator repair in Lakewood, photo from our job records
Refrigerator repair in Lakewood
Refrigerator repair in Lakewood, photo from our job records
Refrigerator repair in Lakewood
Refrigerator repair in Littleton, photo from our job records
Refrigerator repair in Littleton
Refrigerator repair in Littleton, photo from our job records
Refrigerator repair in Littleton
Call Now Book Online