Thermador built-in and Freedom column refrigerators mostly show alarms rather than numbered codes: a temperature alarm, a door alarm, a sensor fault or a low-voltage warning. If a sensor fault appears, run the built-in self test and give the result to the technician. Service manuals list E01 (fresh food sensor) and E02 (freezer sensor), plus E06 and E07 for evaporator sensors found during the self test.
Thermador refrigeration includes Freedom columns, built-in bottom-freezer and French door models. Their displays warn you with an ALARM symbol, flashing temperatures and tones, and show error messages mainly during a self test. The alarms and self test below come from a Thermador use and care manual; the numbered codes come from Thermador service manuals as listed by a repair reference. Turn off the unit at the breaker before any hands-on check.
Thermador Refrigerator and Alarms error codes and what they mean
| Code | What it means | What to try |
|---|---|---|
Temperature alarm (ALARM symbol, temperature flashing) |
The freezer or refrigerator is too warm. Causes include a power failure, a large load of warm food, a door left open, or an appliance fault. | Press ALARM to stop the tone; the highest temperature reached is shown briefly. Find the cause. The alarm clears itself when the set temperature is reached again. |
Door alarm |
A door is not closed properly or has been open too long. | Close the door fully and check that nothing blocks it or the gasket. The warning goes out once the door closes. |
Sensor fault message |
A technical defect is possible, usually a temperature sensor. Call a technician |
Run the appliance self test (below) and note the result for the technician. |
Low voltage (display light goes out) |
Mains voltage has dropped below the permitted limit. Buttons will not respond until voltage returns. | Nothing to do on the unit. If it lasts, contact your power company. |
Self test |
Built-in diagnostic. If a fault is found, the ALARM symbol and an error message appear; if not, the set temperature shows when the test ends. | Switch the unit off and wait 5 minutes with the door closed. Switch it on, then hold SETUP and ALARM OFF together for 5 seconds. Write down any message shown. |
E01 |
Fresh food compartment temperature sensor open or shorted. Call a technician |
Reset the breaker for 5 minutes. If it returns, call for service. |
E02 |
Freezer compartment temperature sensor open or shorted. Call a technician |
Reset the breaker for 5 minutes. If it returns, call for service. |
E06 |
Refrigerator evaporator sensor failure. Shown only after the self test, not during normal use. Call a technician |
Call for service and give the code. |
E07 |
Freezer evaporator sensor failure. Shown only after the self test. Call a technician |
Call for service and give the code. |
1-1-1 / 1-2-1 / 1-3-1 / 1-4-1 / 2-1-1 / 2-2-1 / 2-3-1 |
Ice maker fault codes listed in Thermador service manuals. The specific meanings are not published for owners. Call a technician |
Make sure the ice maker water supply is on and the bin is seated. Reset the breaker for 5 minutes; if the code returns, call for service. |
2 flashes |
Listed in service manuals as a signal problem from the main control board (no 3-6 VDC signal to a component). Call a technician |
Reset the breaker. If it returns, call for service. |
E + number (other) |
Control-detected fault. Call a technician |
Reset by turning off the breaker for 5 minutes. If it returns, call for service and give the exact code. |
What we actually find on Thermador refrigerators in the Denver area
The codes above come from Thermador’s own documentation. This section shows what our technicians found once they opened the machine. Since 2023 we have handled 8 Thermador refrigerator service calls across the Denver metro and Boulder County. Every number here comes from our own job records.
The refrigerator repairs we do most often (all brands)
Our notes on Thermador refrigerators are too thin to rank by brand alone, so here is what we found across all 1685 refrigerator calls in our records:
- Compressor or sealed system: 167 calls
- Evaporator or condenser fan: 121 calls
- Control or inverter board: 120 calls
- Ice maker: 109 calls
- Defrost system: 66 calls
- Thermistor or sensor: 37 calls
- Water inlet valve: 32 calls
Recent Thermador refrigerator calls
- Boulder (80301), September 2026: Thermador refrigerator ice maker not working. Repair: door gasket replaced (00244425).
- Boulder (80301), February 2026: Thermador refrigerator ice maker not working. Repair: evaporator or condenser fan replaced.
Refrigerator repairs from $250. Home diagnostic visit from $59, credited toward your repair. Call 720-230-1229.
Source: The Appliance Team service records, 2023–2026. Customer details removed.
What you can safely check yourself
- Note the exact message or code and whether the ALARM symbol is lit.
- Check that all doors and drawers close fully and nothing blocks the gaskets.
- Keep doors closed and avoid adding large warm loads until temperatures recover.
- Make sure the ventilation grille is not blocked.
- Reset by switching the unit off at the breaker for 5 minutes, then run the self test.
- Check the temperature with a thermometer in a glass of water.
When to call a technician
- The self test shows a sensor fault or any error message.
- The temperature alarm returns with the doors closed.
- The freezer is soft or the fresh food section is above 41 degrees.
- Ice maker codes return after a reset.
- The compressor runs constantly or not at all.
How to prevent this
Many of these breakdowns start with maintenance that was skipped. These guides show what to check, how often, and what happens if you don't:
Frequently asked questions
Why is my Thermador refrigerator beeping?
The usual causes are the door alarm or the temperature alarm. Close the doors and press ALARM to silence it; the temperature alarm clears itself once the unit cools back down.
How do I run the self test on a Thermador refrigerator?
Switch the unit off for 5 minutes with the door closed, switch it on, then hold SETUP and ALARM OFF together for 5 seconds. Any error message that appears should be given to the technician.
What does E01 mean on a Thermador refrigerator?
Thermador service manuals list E01 as a fresh food compartment sensor that is open or shorted. A technician needs to test the sensor and wiring.
Why is my Thermador display dark?
If the display light goes out and buttons do not respond, the unit may be seeing low voltage. It recovers on its own when voltage returns; if it lasts, contact your power company.
Sources: manualslib.com, mypros.plus, mypros.plus, mypros.plus, mypros.plus, thermador.com. Codes and meanings can vary by model; check your owner's manual.