LG refrigerator codes usually show as "Er" plus two letters. Er FF, Er rF, and Er IF are fan problems, often caused by ice around the fan; Er dH and Er dS are defrost faults; and sensor codes like Er rS, Er FS, and Er dS mean a temperature sensor has failed. Fan codes can sometimes clear after a full manual defrost, but most other codes need a technician.
When an LG refrigerator finds a problem, it flashes a code on the temperature display. On many US models it appears as "Er" followed by a code, like "Er FF". Some codes are easy to clear, but many mean a fan, sensor, defrost, or control part has failed. The list below combines LG's support library and trusted repair-parts references; your display may vary by model. The list combines the manufacturer's own code lists with service manuals and repair-parts references. Rows marked "on some models" or "service references" come from those repair sources, so the meaning can vary by model; check your owner's manual when in doubt.
LG Refrigerator error codes and what they mean
| Code | What it means | What to try |
|---|---|---|
Er FF (also E FF or F) |
Freezer fan motor error. Ice or frost around the fan often stops it from turning, frequently after the door was left ajar or the freezer was overpacked. | Move food to a cooler, unplug the fridge, and leave both doors open for at least 24 hours to fully defrost. Put towels down. Don't use a hair dryer. Plug back in and allow 24 to 48 hours to cool. |
Er rF |
Refrigerator compartment fan error, usually from ice around the fan. | Same as Er FF: a full manual defrost with the unit unplugged. If the code returns, the fan or defrost system needs service. |
Er IF (may read F1) |
Ice maker fan error, usually from a blockage such as ice buildup. Call a technician |
Check that the ice compartment door seals fully. LG recommends service; a full manual defrost may temporarily clear ice around the fan. |
Er CF |
Condenser fan error. The compressor overworks if this fan is blocked or failed. Call a technician |
Unplug the fridge and make sure nothing is blocking the rear lower grille. The fan itself needs a technician. |
Er dH (also FdH, dHF, F dH, r dH) |
Defrost error. The evaporator didn't warm enough during defrost and may be iced over. Call a technician |
Possible causes include a failed defrost heater, temperature fuse, relay, or clogged drain. Schedule repair; a manual defrost only buys time. |
Er dS (also F dS / r dS) |
Defrost sensor error. The evaporator may freeze over. Call a technician |
Schedule repair to test and replace the sensor. |
Er rS / Er r1 / Er RS1 |
Refrigerator (upper) temperature sensor error. Call a technician |
Schedule repair. The fridge may still cool but won't regulate temperature well. |
Er FS |
Freezer temperature sensor error. Call a technician |
Schedule repair to test the sensor and its connections. |
Er rt |
Room (ambient) temperature sensor error. Call a technician |
Schedule repair. |
Er IS (may read 1S or 15) |
Ice maker temperature sensor error. Ice may stop dispensing. Call a technician |
Schedule repair. |
Er It |
Ice maker motor error. Call a technician |
Schedule repair. |
Er CO |
Communication error between the main control board and the display. Call a technician |
Unplug the fridge for 60 seconds, then plug it directly into a wall outlet. If the code stays, the boards or wiring need service. |
Er C1 |
Communication error between the dispenser and display. Call a technician |
Try a 60-second power reset. If it persists, schedule repair. |
Er gF |
Water flow sensor error. Often caused by a closed valve, kinked line, or wrong water pressure. | Unplug for 60 seconds and wait up to 5 minutes after restart. Make sure the water supply valve is fully open and the line behind the fridge isn't kinked. Replace an old water filter. |
Er FU |
Cooling cycle error. The freezer isn't getting cold enough. Call a technician |
Power-reset the fridge on a wall outlet, set the freezer to 0°F, keep vents clear of food, and check door gaskets seal. If it continues, the sealed system may need service. |
Er CH / Er CL (also CH E / CL E) |
Refrigerant system error on the high- or low-pressure side. Call a technician |
This involves the sealed refrigerant system. Do not attempt DIY; schedule repair. |
Demo / Display mode (OFF) |
Store display mode. The lights and display work, but the fridge and freezer do not cool. | With a door open, press and hold the Refrigerator button and press Express Freeze (or Ice Plus) 3 times; on some models, hold both buttons for 3 seconds. A tone confirms demo mode is off. Button names vary by model, so check your manual. |
Er 22 |
Compressor relay problem. The fridge may stop cooling. Call a technician |
Unplug for 60 seconds and plug directly into a wall outlet. If the code returns or the fridge warms up, move food to a cooler and schedule repair. |
Er 33 |
Compressor relay problem, on some models. Call a technician |
Schedule repair. A technician needs to test the relay, compressor, and control board. |
Er 67 |
A door isn't closing fully, on models with an auto-close or auto-open door. | Check for food, bins, or shelves blocking the door, and make sure the fridge is level. If the door closes freely and the code stays, schedule repair. |
Er SS |
Pantry (convertible drawer) temperature sensor error, on models with a temperature-controlled pantry. On some models LG lists SS as the water tank temperature sensor instead. Call a technician |
Schedule repair to test the sensor and wiring. |
Er HS |
Humidity sensor error, on some models. Call a technician |
Schedule repair to test the sensor and wiring. |
Er Od |
Wi-Fi modem or communication error on smart models. Cooling usually continues. Call a technician |
Unplug for 60 seconds and restart. If the code stays, the Wi-Fi module or its wiring needs service. |
Er Ad / Er dr |
Auto door motor error. The door motor didn't reach its position within 5 seconds, on models with an automatic door. Call a technician |
Make sure nothing blocks the door, then try a 60-second power reset. If it persists, schedule repair. |
Er AS (also L AS / r AS) |
Auto door motor reed switch error, on models with an automatic door. Call a technician |
Schedule repair. |
EID / EIU |
Freezer ice maker error, on some models. EID is an ice maker sensor failure; EIU is an ice maker assembly failure. Call a technician |
Schedule repair. Turning the ice maker off avoids repeated errors until it's fixed. |
Sb (may read S6, 5b, or 56) |
Sabbath mode is on. Not a fault; lights, dispenser, and some alarms are disabled. | On many models, press and hold Freezer and Wi-Fi for 3 seconds. Sabbath mode also turns off on its own after 96 hours. |
88 |
Display check shown at power-up. Not an error. | No action needed. If 88 stays lit and the fridge doesn't cool, try a 60-second power reset, then schedule repair. |
Er r2 / Er RS2 / Er F2 / Er 3 |
Second (lower) refrigerator temperature sensor error. Call a technician |
Unplug the appliance for 5 minutes, then restart. If the code returns, write it down and call a technician. |
Er tt |
Water tank error on models with an internal water tank: tank missing, not inserted correctly, or the detection sensor failed. | Check that the water tank is installed and seated. If the code stays, schedule repair. |
Lo / HI |
Room temperature warning, not a fault: Lo means the room is below about 14 F (-10 C); HI means it is above about 122 F (50 C). | Move the fridge to a room within its rated temperature range, such as out of an unheated garage in winter. |
Er dF |
On some models (service references): abnormal defrost. Call a technician |
Unplug for 2 minutes to restart defrost. If it returns, schedule repair. |
Er dP |
On some models (service references): damper motor error. Fridge temperature may be too warm or too cold. Call a technician |
Unplug the appliance for 5 minutes, then restart. If the code returns, write it down and call a technician. |
Er CS |
On models with a convertible drawer (service references): convertible room sensor open or shorted. Call a technician |
Unplug the appliance for 5 minutes, then restart. If the code returns, write it down and call a technician. |
Er Co2 |
On some models (service references): communication error between the sub board and the display. Call a technician |
Unplug the appliance for 5 minutes, then restart. If the code returns, write it down and call a technician. |
Er IM / Er IM2 / Er IM3 / Er IK |
On some models (service references): ice maker unit or ice maker sensor fault. Call a technician |
Turn the ice maker off and on. If the code stays, schedule repair. |
Er Id / Er IU |
Freezer shelf ice maker sensor (Id) or ice maker assembly (IU) error. Same faults as EID / EIU. Call a technician |
Unplug the appliance for 5 minutes, then restart. If the code returns, write it down and call a technician. |
Er 1-Er 12 (older models) |
Older LG models use number codes (service references): Er 1 fridge sensor, Er 3 second fridge sensor, Er 4 defrost sensor, Er 5 and Er 10 main-to-display communication, Er 6 cooling fan, Er 7 freezer fan, Er 8 and Er 11 ice maker sensor, Er 9 defrost failure, Er 12 ice maker unit. Call a technician |
Write down the number. Fan and defrost codes may clear after a full manual defrost; others need a technician. |
What we actually find on LG refrigerators in the Denver area
The codes above come from LG’s own documentation. This section shows what our technicians found once they opened the machine. Since 2023 we have handled 253 LG refrigerator service calls across the Denver metro and Boulder County. Every number here comes from our own job records.
| Code | Our calls | What we found |
|---|---|---|
| IF | 2 | Most often: compressor or sealed system. Also seen: evaporator or condenser fan. |
| CF | 1 | Evaporator or condenser fan. |
The LG refrigerator repairs we do most often
Across all 253 LG refrigerator calls, with or without a code on the display:
- Compressor or sealed system: 68 calls
- Evaporator or condenser fan: 19 calls
- Ice maker: 9 calls
- Control or inverter board: 5 calls
- Water inlet valve: 3 calls
- Damper: 2 calls
- Defrost system: 2 calls
Recent LG refrigerator calls
- Thornton (80602), October 2026: LG refrigerator making noise. Repair: evaporator or condenser fan replaced.
- Arvada (80005), October 2026: LG refrigerator not starting. Repair: compressor or sealed system replaced.
- Denver (80205), September 2026: LG refrigerator not cooling. Repair: damper replaced (4901JB1003F).
- Lafayette (80026), September 2026: LG refrigerator not starting. Repair: compressor or sealed system replaced.
LG refrigerator repairs from $260. Home diagnostic visit from $59, credited toward your repair. Call 720-230-1229.
Source: The Appliance Team service records, 2023–2026. Customer details removed.
Video: LG refrigerator error codes
Video by LG USA Support
What we see on Denver calls
- An error code points to the system that reported the fault, not always to the part that failed.
- The LG refrigerator repairs we do most often across the Denver metro and Boulder County: compressor or sealed system (68 calls), evaporator or condenser fan (19) and ice maker (9).
- Recent call: Thornton (80602), October 2026: LG refrigerator making noise. Repair: evaporator or condenser fan replaced.
Don’t want to do it yourself? Call 720-230-1229.
What you can safely check yourself
- Note the exact code and model number before calling; it speeds up diagnosis.
- Power reset: unplug the fridge for 60 seconds and plug it directly into a wall outlet, not a power strip.
- For fan codes, do a full manual defrost: empty the fridge, unplug it, prop the doors open for 24 hours, and catch meltwater with towels.
- Check that doors close fully and gaskets seal; close a sheet of paper in the door and make sure it resists being pulled out.
- Keep food away from the air vents inside the fridge and freezer.
- For Er gF, confirm the water supply valve is open and the line isn't kinked.
When to call a technician
- Any sensor, defrost, or communication code (rS, FS, dS, dH, CO, C1) that persists after a reset.
- Fan codes that return within days after a full defrost.
- Er CH, Er CL, or Er FU with warm temperatures, which can involve the sealed system.
- Food is warming and you can hear no fans or compressor running.
How to prevent this
Many of these breakdowns start with maintenance that was skipped. These guides show what to check, how often, and what happens if you don't:
Frequently asked questions
How do I clear Er FF on my LG refrigerator?
Er FF usually means ice is blocking the freezer fan. Unplug the fridge, leave the doors open for at least 24 hours to defrost, then plug it back in. If the code returns, a defrost part has likely failed and needs a technician.
Why is my LG fridge display on but not cooling?
It may be in demo (display) mode, which turns off cooling but leaves the lights and display on. Follow your manual to exit demo mode. If it is not in demo mode, look for an error code or call for service.
What does Er dH mean on an LG refrigerator?
Er dH is a defrost error. The fridge couldn't melt frost off the evaporator coil, which can block airflow and cause poor cooling. It usually needs a technician to test the defrost heater, fuse, and sensor.
Can I keep using my fridge with an error code?
Often yes for a short time, but watch temperatures closely. Sensor and fan codes can lead to warming or freezing in the wrong compartment, so use a thermometer and schedule repair soon.
Sources: lg.com, lg.com, lg.com, homeserve.com, hunker.com, lg.com, lg.com, searspartsdirect.com, mypros.plus. Codes and meanings can vary by model; check your owner's manual.