dishwasher
Replaced the water inlet hose.
Repaired · 90-day warrantySame-day dishwasher repair across Boulder, including Downtown Boulder, Mapleton Hill, Whittier. All brands, written quote before any work.
The Appliance Team repairs dishwashers of all brands in Boulder, including panel-ready built-ins, and we often have same-day openings. We start with a diagnosis and a written quote, the service call (from $59) is waived when you approve the repair, and parts and labor are covered for 90 days.
Cloudy glasses in Boulder are rarely a hard-water story. The city's water averages about 42 mg/L of hardness, which is soft, so the white crust common elsewhere in the metro is uncommon here. Instead, soft water and a full scoop of detergent can leave a film or slowly etch glassware. Before we replace parts on a Boulder dishwasher that 'won't clean,' we look at detergent, rinse aid and water temperature.
Many Boulder homes have been remodeled instead of rebuilt, and a remodeled kitchen in Table Mesa or Martin Acres often has a panel-ready dishwasher matched to the cabinets. These units are mounted tightly to the countertop and side cabinets, with a custom door panel that adds weight to the hinges. Pulling one out takes patience: we protect the panel and flooring, disconnect water and drain carefully, and check the door springs and cables, which wear faster under a heavy panel.
Older kitchens in Mapleton Hill and Whittier bring different issues. Dishwashers were often added decades after the house was built, sometimes on an aging supply line or a drain tied into older plumbing. A dishwasher that drains slowly may have a kinked hose, a missing high loop or a clogged air gap rather than a bad pump.
In rentals and condos near CU and on University Hill, dishwashers run hard. Food debris overloads filters, utensils jam wash arms, and door latches and switches wear out. Those are usually straightforward repairs, but they are best caught before a small leak damages the subfloor.
With Boulder's soft water, excess detergent is the likely cause, and etching from it is permanent on the glass. We check water temperature, the rinse aid dispenser and wash arms, and help you adjust the detergent dose.
A clogged filter, kinked drain hose, blocked air gap or failed drain pump can leave standing water. We clear whichever one is blocked, then run a drain test on the pump.
Door springs and cables are sized for the panel weight. If a panel was added or changed, or the springs are worn, we replace them and adjust tension.
We test the heating element, thermostat or thermistor, and the control. On many European models, drying relies on rinse aid and condensation, so we check that too.
Worn door gaskets, a cracked spray arm or too much suds from the wrong detergent are common causes. We find the source before replacing anything.
A worn dispenser latch, a weak actuator or a tall pan blocking the door can leave the tablet sitting in the cup at the end of the cycle. We test the actuator and the control signal that fires it, and check how the lower rack is loaded.
From our job records: 136 dishwasher repairs completed in Boulder since January 2024.
We counted 36 dishwasher repair jobs in Boulder in our job records. This is what those jobs needed and which brands they were, so you can see what is likely wrong with yours before we arrive.
Brands we repaired most: Bosch (5), KitchenAid (4), Miele (4), GE (2), JennAir (1), Whirlpool (1).






Replaced the water inlet hose.
Repaired · 90-day warrantyDishwasher upper rack wheels replacement
Repaired · 90-day warrantyDoor cables replacement
Repaired · 90-day warrantyDrainage pump replacement
Repaired · 90-day warrantyCirculation pump cleaning
Repaired · 90-day warrantyDrain pump replace, cleaning
Repaired · 90-day warrantyJennAir dishwasher diverter motor, wash motor hose and water inlet hose replacements
Repaired · 90-day warrantySafety water level switch cleaning
Repaired · 90-day warrantyBosch dishwasher door latch replacement
Repaired · 90-day warrantyDrainage cleaning, water supply line cleaning
Repaired · 90-day warrantyReal jobs from our records. Customer details are never shown.
Dishwasher Repair starts at $179*.
| Repair | From* |
|---|---|
| Door latch or switch | $179+ |
| Drain pump | $179+ |
| Wash or circulation pump | $259+ |
| Control board | $259+ |
* Labor only; parts are quoted separately.
See full price list →Bosch and Miele are among the most common dishwashers we see in Boulder's remodeled kitchens, along with Thermador, JennAir, Monogram and Fisher & Paykel DishDrawers. We repair Whirlpool, KitchenAid, GE, Samsung, LG and Frigidaire as well. Many Bosch and Miele units have a leak sensor in the base that stops the machine if water collects there.
Restaurants on and around Pearl Street, 28th Street kitchens, breweries and hotels use commercial dish machines, and we diagnose and repair those for Boulder businesses.
Restaurant equipment repair →Expect roughly 9 to 12 years from most dishwashers. Boulder's soft water spares them the heavy scale that shortens their lives elsewhere in the metro, so wear here comes mostly from use and age. Apply the 50% rule: when a repair would cost more than half the price of a comparable new unit, replacing is usually smarter. Pumps, latches, gaskets, inlet valves and dispensers are nearly always worth fixing. On a panel-ready machine in a remodeled kitchen, repair also preserves a custom panel that a new model may not fit.
4.9 from 686 reviews · 541 on Google
“Oleksii did a great job repairing our Bosch dishwasher. He came out and determined what parts were needed, ordered them, and then returned to make the needed repairs. He was polite, efficient, and took the extra step of making sure the dishwasher was properly balanced and aligned.”
“Getting an appointment was extremely fast and easy. Communication was great, and Serge diagnosed the problem with our dishwasher. Thank you!”
“Thank you for service, the dishwasher works like new. Sergii did an excellent job.”
In soft water, detergent does not get used up the way it does in hard water, so leftovers can leave a film or etch glass. Try using less detergent and adding rinse aid. If the film persists, we check temperature, spray arms and the dispenser.
Yes. We service panel-ready and built-in units from Bosch, Miele, Thermador and others and take care removing and reinstalling custom panels.
Bosch dishwashers have a float switch in the base pan. If water reaches it, the machine stops and drains. We find the leak, dry the base and reset the unit.
Yes. We repair dishwashers in student rentals, condos and apartments around campus and coordinate with landlords and property managers.
Usually not. City of Boulder water averages about 2.4 grains per gallon, which is already soft, so a softener adds little for the dishwasher and can make detergent etching worse. Adjusting the detergent dose and the machine's hardness setting is the better fix.
Yes. Many 1960s-70s Table Mesa kitchens have been updated with Miele, Bosch or Thermador units. We diagnose drain pumps, circulation pumps, heaters and controls on these European machines and handle the integrated panels with care.
Water left in the tub or dishes coming out dirty? Book online or call and we will find the pump, valve or latch that failed.
Boulder is one of our busiest cities for dishwashers: we found 36 dishwasher calls in a sample of our Boulder records. Boulder kitchens have a lot of KitchenAid, Bosch, Miele and LG dishwashers, and the calls ranged from flashing-light codes and units that wouldn’t turn on to leaks, heating problems, a new wash pump and installations.












| Dishwasher | What the customer saw | What we found or did |
|---|---|---|
| KitchenAid | Flashing light code | Code diagnosis and repair |
| Dishwasher | Would not turn on | Latch, power and control diagnosis |
| LG | Not washing properly | Wash system diagnosis |
| Dishwasher | Not heating | Heating diagnosis |
| Dishwasher | Leaking | Leak repair |
| Dishwasher | Weak wash | Replaced the wash pump |
| Bosch | Not working properly | Diagnosis and repair |
| New dishwasher | Installation | Installed and tested |
Many KitchenAid and Whirlpool dishwashers report faults by flashing a light a set number of times. The count points to a heating, drain, water supply or sensor problem. We read the pattern, run the diagnostic cycle and test the related part.
Boulder’s water is softer than much of the metro, which is good for dishwashers, but soft water and too much detergent cause cloudy etching on glasses. Use less detergent and keep rinse aid filled. Bosch and Miele units have a water-hardness setting that should match Boulder water.
We also install dishwashers in Boulder: we level them, secure them, connect the supply and drain with a proper high loop and run a full cycle to check for leaks.
All of Boulder, plus Gunbarrel, Niwot, Louisville, Lafayette and Superior.
Bosch, Whirlpool, KitchenAid, Maytag, GE, Samsung, LG, Frigidaire, Miele and Thermador make up most of the dishwashers we see. Bosch most often needs drain pumps, door latches and leak repairs; Whirlpool, KitchenAid and Maytag need drain pumps, door gaskets and heating parts; GE needs pumps, latches and controls; Samsung and LG need drain pumps, door latches and leak sensor checks. We stock the common parts.
| Brand and code | Usual meaning |
|---|---|
| Bosch E24 / E25 | Not draining: filter, hose or drain pump |
| Bosch E15 | Water in the base pan from a leak |
| Samsung LC / LE | Leak detected |
| Samsung 5C / OC | Drain problem or overfill |
| LG AE / E1 | Leak sensor triggered |
| LG OE | Not draining |
| KitchenAid / Whirlpool flashing lights | Count of flashes points to heating, drain, water or sensor faults |
| GE blinking lights or H2O codes | Fault pattern we read in service mode |
We run a short cycle and watch it fill, wash, drain and heat. We read any code, pull the filter and inspect the sump, check the drain hose and high loop, and test the pump, inlet valve, heater, float and door latch as needed. You get the price before work starts. After the repair we run a full cycle with the kick plate off to confirm there are no leaks.
The door latch or its switch, the child lock, a blown thermal fuse or the control. If the panel lights but nothing happens, the latch is the first suspect.
A clogged filter, scaled or cracked spray arms, a weak circulation pump or low water temperature. Clean the filter and spray arms first; it fixes more dishwashers than any part.
Filter, drain hose, disposal knockout on new installs, or the drain pump.
Door gasket or bottom seal, spray arm or sump, hose clamps, inlet valve, or too much suds.
Food trapped in the filter and sump, or dirty water flowing back from the sink because the drain hose lacks a high loop.
Turn off the supply valve and the breaker and call.
Tell us the brand, the symptom and any flashing-light pattern when you book, and we bring the most likely parts, including for Bosch, Miele and KitchenAid units.
Every repair comes with a 90-day parts and labor warranty. If the same problem returns within that time, we come back and fix it at no charge. We also explain what failed, what we replaced and whether anything else looks close to failing, so you can plan ahead instead of being surprised.
The home service visit starts from $59 and repairs start from $150, parts and labor included. You get the exact price before any work, and every repair has a 90-day parts and labor warranty. If the same problem returns within that time, we come back at no charge.