Kenmore Dishwasher Repair
Kenmore and Kenmore Elite dishwasher repair in Denver: leaks, dishes not clean, not draining, won't turn on. 24/7, 90-day warranty.
Kenmore dishwasher repair in Denver: leaks, dishes not clean, not draining, dishwashers that won’t turn on or keep shutting off, and Kenmore Elite models. We repair Kenmore and Kenmore Elite built-in dishwashers across Denver and 30 nearby cities, 24/7.
4.9★ on Google · $99 service call waived with the repair · Written quote before any work · 90-day warranty on parts and labor · EPA 608 certified technicians · Same-day or next-day visits
On this page: Leaking · Not cleaning · Not draining · Won’t turn on · Racks and door · Quick checks · Cities we serve
Kenmore doesn’t build its own dishwashers. Most Kenmore dishwashers we see, including the model numbers that start with 665, are made by Whirlpool and share their pumps, spray arms, diverter motors and control boards with Whirlpool, KitchenAid and Maytag. That makes parts easy to get and the repairs predictable. Our technicians, with more than 30 years of combined experience and over 10,000 appliance repairs behind the company, see the same Kenmore failures again and again: spray arms, diverter motors, drain pumps and hoses, and control boards.

1. Leaking
Leaks are the most common reason Kenmore owners call us, and the cause is often inside the tub, not at the door. In May and June 2025 two leaking Kenmore dishwashers needed new spray arms: a cracked arm sprays water sideways at the door. In May 2025 another leak came from the diverter motor. In February 2025 a leaking Kenmore needed a new drain hose.
One Kenmore leaked from the left side on almost every cycle. We found the control was powering the diverter motor the whole time, so it kept running and built up excess pressure in the lower spray arm, which pushed water out. That is the kind of problem you only find by watching the dishwasher run.
Door leaks are usually the gaskets. In July 2026 a leaking Kenmore Elite needed a new spray arm and door gasket.
2. Dishes not clean
- Spray arms. In February 2024 a Kenmore that was running slowly and not cleaning needed new upper and lower spray arms and a rack adjuster. In October 2024 a two-year-old Kenmore that left soap residue and then started leaking needed a new spray arm.
- Circulation pump. In March 2025 a Kenmore that wasn’t washing needed a new circulation pump.
- Heating. In September 2024 one Kenmore needed a new heating element, and another that showed Clean but left dishes dirty needed a repair in the heating element circuit.

Kenmore dishwasher leaking, or not cleaning? Call 720-230-1229. We answer 24/7 and can usually be there the same or next day.
3. Not draining
Start with the filter. In April 2025 a Kenmore that wasn’t draining was fixed by cleaning the filter and testing the drain. When that isn’t enough, the drain pump is next: in May 2025 we replaced one, and in November 2025 a noisy drain pump needed replacing as well.

4. Won’t turn on, or keeps shutting off
- Control board fuse. In February 2024 a Kenmore that wouldn’t turn on needed a new fuse on the control board, plus a cleaning around the circulation pump and filter.
- Control board. In April 2025 a Kenmore that kept clicking and shutting off needed a new control board. In October 2025 a Kenmore showed E2 and wouldn’t run, and its control board was replaced.
- Diverter motor. In June 2025 a Kenmore that wouldn’t turn on turned out to have a failed diverter motor.
- Door switches. In November 2025 a Kenmore that wasn’t working properly needed two new door switches.
- A simple reset. In November 2025 a Kenmore that wouldn’t turn on came back after it was unplugged and plugged back in.

Kenmore Elite dishwashers have their own boards and latches. In December 2025 a Kenmore Elite that wouldn’t turn on needed a new board and latch, and in April 2026 we were called to another that wouldn’t turn on.

5. Racks, rails and door
Broken rack parts make a dishwasher hard to use even when it washes fine. In April 2026 a Kenmore Elite needed a new side rail for its rack. In April 2025, while replacing a control board, we also found the top of an older door rusted through, which is worth knowing before you decide how much to spend on it.

From our Kenmore dishwasher service log
- February 2024, won’t turn on. A new fuse on the control board, pump area and filter cleaned.
- February 2024, slow and not cleaning. New upper and lower spray arms and a rack adjuster.
- February 2025, leaking. A new drain hose.
- March 2025, not washing. A new circulation pump.
- April 2025, shutting off and clicking. A new control board.
- May 2025, leaking. A new diverter motor.
- June 2025, won’t turn on. The diverter motor had failed.
- October 2025, E2, won’t run. A new control board.
- November 2025, not working properly. Two new door switches.
- July 2026, Kenmore Elite leaking. A new spray arm and door gasket.
Before you call: three quick checks
- Clean the filter at the bottom of the tub and check that the spray arms turn freely.
- Reset the power. Unplug the dishwasher or turn off its breaker for a minute; on one of our calls that alone brought a Kenmore back.
- Use dishwasher detergent only, never dish soap, and run the hot water at the sink before you start a cycle.
Repair or replace?
Spray arms, hoses, drain pumps, diverter motors, door switches and gaskets are inexpensive repairs on a Kenmore dishwasher. A control board costs more, so on an older dishwasher with a rusted door or tub we give you an honest repair-versus-replace number. Either way, you get a written quote before any work starts, and the $99 service call is waived if you go ahead with the repair.
Kenmore dishwasher repair near you
We repair Kenmore and Kenmore Elite dishwashers in Denver and every city we serve across the metro, with same-day or next-day visits. Tap your city to see local service details:
Related: Kenmore appliance repair · Kenmore refrigerator repair · Kenmore washer repair · Whirlpool dishwasher repair · Dishwasher repair
Common Kenmore Dishwasher Problems
Why Choose The Appliance Team?
Denver's trusted appliance repair company — professional service you can count on.
Same-Day Service
Same-day appliance repair in Denver — call early and we can often be there today. No waiting around for weeks.
90-Day Warranty
90-day warranty on parts and labor for every repair we perform.
Certified Technicians
Our Denver appliance repair technicians are trained on all major brands and use genuine manufacturer parts.
Transparent Pricing
Service fee waived with repair. No hidden charges, no surprises.
Frequently Asked Questions
Most Kenmore dishwashers we repair, including models starting with 665, are made by Whirlpool and share parts with Whirlpool, KitchenAid and Maytag. Some Kenmore Elite models use other platforms. Your model number tells us which parts fit.
On our calls the most common causes were cracked spray arms, a failed diverter motor, a drain hose and worn door gaskets. Dish soap instead of dishwasher detergent also causes leaks.
Try turning the power off for a minute first. If it still won't start, the cause is often the control board or its fuse, the door switches or latch, or a failed diverter motor.
Clean the filter first. After that, the usual causes are worn or cracked spray arms, a weak circulation pump, or a heating problem.
The service call is $99 and is waived if you go ahead with the repair. You get a written quote for parts and labor before we start, so there are no surprises.
Kenmore dishwasher leaking?
Call 720-230-1229. We answer 24/7 and send a technician the same or next day. 90-day warranty on parts and labor.





