washer
Disassembled the washer and cleaned the drain pump, filter, and drain hose.
Repaired · 90-day warrantySame-day washer repair across Berthoud, including Old Town Berthoud, Heron Lakes, Prairiestar. All brands, written quote before any work.
Berthoud homeowners call The Appliance Team for washing machine repair on every major brand, and same-day service is often available. We pinpoint the problem, give you a written price, waive the service call (from $59) if you go ahead, and stand behind the repair with a 90-day parts and labor warranty.
Berthoud's washers live in very different spaces. In the original town near Mountain Avenue, a machine may be wedged into a basement corner or a narrow closet with old hookups and a short standpipe. In Prairiestar, Wilson Ranch and Harvest Ridge, it is usually a newer front-loader in a main-floor or upstairs laundry room. Out toward Carter Lake, some homes wash with well water.
Because Berthoud roughly doubled between 2010 and 2020, a big share of its washers are high-efficiency front-loaders and low-water top-loaders less than 15 years old. Those machines rely on sensors, door locks and electronic boards, and when one fails, the washer stops with an error code rather than limping along. In Heritage Ridge and Serenity Ridge, we often replace a single drain pump, lock or pressure sensor and the machine is back in service.
Old Town Berthoud and Berthoud Heights West bring older plumbing into the picture. Original shutoff valves can seize or drip, drain standpipes may be too short for modern pumps, and tight closets make it hard to keep a washer level. Those conditions cause siphoning, overflows and heavy vibration that look like machine failures. We check the hookups along with the washer.
The town's water reports we reviewed do not list hardness, so we look for scale on inlet valves and heaters rather than assume. Private wells on acreage around Berthoud are another matter, as some carry iron or sediment that can stain laundry and clog inlet screens faster.
A drain fault often keeps the door locked because water is still in the tub. We drain the washer safely, clear or replace the pump and test the door lock assembly.
A drain hose pushed too deep into a short standpipe can siphon water out as it fills, which we see in older Berthoud homes. A stuck inlet valve or failed pressure sensor can also cause overfilling.
A partly blocked pump, a slipping belt or a failing motor control keeps the drum from reaching full spin. We test each part and look for an unbalanced-load sensor fault.
On well-water homes, iron in the water is a likely cause. Inside the washer, a corroded drum support or a rusty part can also mark clothes, and we check both.
Worn shock absorbers or suspension rods, an unlevel floor or leftover shipping bolts on a new install all produce violent spin. We correct leveling and replace worn suspension parts.
Worn agitator dogs, a failed shifter or a loose drive coupling are typical on older top-loaders. We open the machine and replace the worn part.
We counted 67 washer repair jobs in Berthoud and nearby Longmont in our job records. This is what those jobs needed and which brands they were, so you can see what is likely wrong with yours before we arrive.
Brands we repaired most: GE (11), Samsung (8), Whirlpool (7), Maytag (4), KitchenAid (2), Bosch (2).






Disassembled the washer and cleaned the drain pump, filter, and drain hose.
Repaired · 90-day warrantyReplaced the user control board.
Repaired · 90-day warrantyDisassembling the washer housing; cleaning the drain pump, filter, and drain hose; reassembling the washer
Repaired · 90-day warrantyReal jobs from our records. Customer details are never shown.
Washer Repair starts at $179*.
| Repair | From* |
|---|---|
| Lid lock or door latch | $179+ |
| Drain pump | $179+ |
| Door boot seal | $259+ |
| Drive motor or control board | $259+ |
| Bearings or transmission | $479+ |
* Labor only; parts are quoted separately.
See full price list →We repair Whirlpool, Maytag, GE, LG, Samsung and Kenmore washers in Berthoud homes of all ages. Larger homes in Heron Lakes often have Electrolux, Bosch or Miele front-loaders, and we service Speed Queen for owners who want a machine built to last. Miele and Bosch use brand-specific diagnostics and parts, so the model number helps us prepare.
Berthoud businesses, from the TPC Colorado clubhouse to companies in the Berthoud Tech Center, sometimes run their own laundry equipment, and we repair those commercial washers too.
Commercial laundry repair →Most washers give 10 to 13 years of service, and many in Berthoud's newer subdivisions are well short of that. Pumps, locks, sensors, valves and suspension parts are almost always worth replacing. If a machine near the end of its lifespan needs tub bearings or a main board costing over half the price of a new washer, replacement is often smarter. Miele and Speed Queen tend to justify repairs longer.
4.9 from 686 reviews · 541 on Google
“Zack is great! He fixed my washer leak a year ago. In the meantime, he also cleaned the back of my fridge from dust. This time it was the dryer. The drum was not spinning. Zack spined the drum by hand and he said is the motor. He made a very quick diagnosis. He took the dryer apart and he found few pieces in the engine that were broken. He replaced the engine and everything works great again. The price was also very reasonable. I am very satisfied with Zack's professional work and I highly recommend him. He really knows what he's doing.”
“Serhii was fantastic! He was friendly, knowledgeable, efficient, and kept us informed throughout the entire process. He quickly diagnosed the issue with our washer, ordered the necessary parts, and returned just two days later to complete the repair. The service was professional and seamless from start to finish. We will definitely use this company again in the future if needed”
“I had an excellent experience getting my washer machine fixed. Denys The technician quickly identified the problem and repaired it efficiently. The service was professional, honest, and reasonably priced.”
Usually, yes. We can service many washers in place or pull them out carefully, and we check the hookups and standpipe while we are there.
Yes. We work on Miele, Electrolux, Bosch and other European front-loaders, which need brand-specific parts and diagnostics. A model number at booking helps us prepare.
Some wells carry sulfur, which can leave an odor in laundry and the washer. We check the washer for residue and drain problems, but the water treatment itself is a job for a well or water-treatment specialist.
Almost always. At that age, most failures are a pump, lock, sensor or board, and the rest of the washer is in good shape.
Yes. A torn or mildewed door boot is a common repair. We replace the seal and check the drain area for the debris that often causes the tear.
Standing water in the drum or a machine that will not spin? Book now and we will bring common washer parts on the first visit.