When a KitchenAid refrigerator stops cooling but the lights still work, the cause in our Denver-area calls falls into four groups: a failed defrost system or temperature sensor (the evaporator ices up and cold air cannot get through), a sealed-system problem (compressor not starting or low refrigerant), a failed control board, or an air damper or door seal problem. Check that the vents inside are not blocked, the doors close and seal, and the condenser coils are clean. If the fridge is still warm after a few hours, call a technician before the food spoils.
KitchenAid refrigerators are one of the brands we service most in the Denver metro area. Since January 2024 our technicians have closed about 140 KitchenAid refrigerator jobs, and “not cooling” or “wrong temperature” was the complaint on more than 30 of them, from Arvada and Westminster to Littleton, Parker and Erie. This guide shows what we actually found on those calls and what you can check before you call.
First, a few checks you can do yourself
- Check the temperature settings. The fresh food section should be set around 37°F and the freezer around 0°F. Make sure the fridge is not in a showroom, demo or vacation mode.
- Clear the vents. Most KitchenAid refrigerators blow cold air from the freezer side into the fresh food section through vents at the back. A box or a bag pushed against them is enough to warm up the fridge.
- Close the doors and check the seals. A door that does not close all the way lets warm air in all day. On French-door models, the freezer drawer has to slide in straight and close firmly.
- Clean the condenser coils. They are behind the bottom grille or at the back. Dust and pet hair on the coils make the compressor run hot and long.
- Listen. If the fridge is warm and you hear no fan running inside the freezer, or the compressor clicks on and off every few minutes, write that down for the technician.
- Power reset. Unplug the refrigerator or turn off its breaker for 5 minutes, then turn it back on. On one Denver call a reset was all it took to bring a dispenser back, but if the fridge is still warm after a few hours, the problem is a part.

What we found on KitchenAid “not cooling” calls
These are real KitchenAid refrigerator jobs from our records, with the cause our technician wrote down. Customer names and addresses are never published.
| Date | City | Problem | What we found or did |
|---|---|---|---|
| Sep 2026 | Erie | Temperature issues, freezer door opening by itself | Freezer drawer gears out of line; door gasket replaced |
| Jun 2026 | Arvada | Fresh food section not cooling | Defrost problem: the evaporator thermistor read the wrong temperature; thermistor replacement |
| Jun 2026 | Lyons | Not cooling, display off, light always on | Main control board and display board |
| Mar 2026 | Broomfield | Freezer not cooling | Defrost not working; evaporator defrosted and the defrost system repaired |
| Feb 2026 | Westminster | Not cooling | Compressor not starting; start device installed |
| Jan 2026 | Centennial | Freezer temperature off, fan noise | Control board was not powering the defrost heater; board and thermistor replaced |
| Oct 2025 | Parker | Warmer than it should be, error on the display, throbbing noise | Refrigerant recharge; evaporator fan motor stopping at times |
| Aug 2025 | Lafayette | Temperature issue | Condenser cleaning; temperature sensor checked |
| Jul 2025 | Denver | Ice on the door, melting ice in the fresh food section | Thermistor and temperature sensor replaced |
| Jun 2025 | Erie | Temperature issue | Inverter control board |
| Jun 2025 | Boulder | Leaking and not cooling | Control board |
| Apr 2025 | Littleton | Freezer not cooling | Fresh food and freezer evaporators replaced |
| Mar 2025 | Denver | Not cooling | Low refrigerant |
| Feb 2025 | Englewood | Not cooling | Sealed system repair needed |
| Dec 2024 | Boulder | Not cooling | Air damper replaced |
1. Defrost system and temperature sensors
This was the most common cause on our KitchenAid calls. A KitchenAid refrigerator makes all its cold air at the evaporator coil behind the freezer panel. Several times a day a heater melts the frost off that coil. If the defrost heater, the thermistor (temperature sensor) or the control that runs them fails, frost builds up until air cannot pass through the coil. The freezer may still feel cold while the fresh food section warms up.
- Signs: fresh food section warm while the freezer is still cold, frost or ice on the back panel inside the freezer, water or ice where it should not be, a fan that sounds like it is hitting ice.
- What we did: on an Arvada call the evaporator thermistor was reading 66°F, so the control never ran defrost correctly; on a Centennial call the control board was not sending power to the defrost heater; in Denver a thermistor and temperature sensor were replaced after ice built up on the door.
- Tip: unplugging the fridge for a day melts the ice and makes it cool again for a while, but the same problem comes back until the failed part is replaced.

2. Compressor and sealed system
If the evaporator is not iced and the fans run, but the fridge stays warm, the cold is not being made in the first place. On our calls this was a compressor that would not start (Westminster), low refrigerant (Denver and Parker), evaporators that needed to be replaced (Littleton) and a sealed system that needed repair (Englewood).
- Signs: the compressor clicks on and off, or it runs all the time and the fridge still does not get cold; the coil behind the freezer panel is only partly frosted.
- How we repair it: on sealed-system work our technicians pressure test with nitrogen, pull a vacuum and charge the refrigerant by the factory weight. Our technicians are EPA 608-certified.

3. Control boards
The main control board runs the compressor, fans and defrost. When it fails, the fridge may stop cooling completely, the display may go dark, or the lights may stay on all the time. On a Lyons call the display board stayed off until a button was pressed and the fridge was warm; the main board and the display board were replaced. In Erie the inverter board that drives the compressor had failed, and in Boulder a control board was behind a fridge that was both leaking and warm.

4. Air damper and door seals
- Air damper. The damper is a small motorized door that lets cold air from the freezer into the fresh food section. If it sticks closed, the freezer stays cold and the fridge warms up. We replaced one on a Boulder KitchenAid.
- Door seals and drawers. On an Erie French-door refrigerator the freezer drawer gears were out of line and the door kept opening by itself. A new freezer door gasket and lined-up gears fixed the temperature problem.

From the technician
“With KitchenAid, look at the freezer before you blame the compressor. If the back panel is covered in frost, it is almost always the defrost side: a sensor, the heater or the board that runs them. Do not chip the ice off with a knife. You can puncture the evaporator and turn a defrost repair into a sealed-system repair.” — Zach, technician at The Appliance Team
Repair cost and booking
Our diagnostic visit is from $59 for homes, and the fee is credited toward the repair if you go ahead. The technician finds the cause and tells you the price for the repair before any work starts. We work in 52 Denver-area cities.
- Call 720-230-1229 and tell us the model, how warm it is inside and whether the freezer is still cold.
- See our KitchenAid refrigerator repair page, the KitchenAid refrigerator error codes or the general refrigerator not cooling guide.
How to prevent this
Many of these breakdowns start with maintenance that was skipped. These guides show what to check, how often, and what happens if you don't:
Questions we hear on KitchenAid cooling calls
Why is my KitchenAid fridge not cooling but the freezer works?
Usually the cold air from the freezer is not reaching the fresh food section. On our calls that was most often a defrost problem (frost blocking the evaporator), a failed thermistor or a stuck air damper. Check the vents at the back of the fridge first.
Why is my KitchenAid refrigerator not cooling but the light is on?
The light and display have their own power, so they work even when the compressor or fans do not. A compressor that will not start, low refrigerant, a defrost failure or a failed control board can all cause this.
How do I reset my KitchenAid refrigerator?
Unplug it or turn off its breaker for about 5 minutes, then turn it back on. Give it several hours to cool down. If it is still warm, the problem is a part, not a setting.
Is it worth repairing a KitchenAid refrigerator that is not cooling?
Often yes. Sensors, defrost parts, dampers and many control boards are moderate repairs. Sealed-system work costs more, and our technician will tell you the price before starting so you can decide. The diagnostic fee is credited toward the repair.